Home › SUSPENSION & AXLE › SUSPENSION › REAR NO. 2 SUSPENSION ARM

REAR NO. 2 SUSPENSION ARM > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ HID Headlight System)


    C137785
  1. Remove the nut and separate the rear height control sensor sub-assembly RH from the rear No. 2 suspension arm RH.



3. REMOVE REAR NO. 2 SUSPENSION ARM


    C132489
  1. Remove the bolt, and disconnect the rear No. 2 suspension arm (inner side).



    C132484
  1. Remove the bolt, nut and the rear No. 2 suspension arm (outer side) from the rear axle carrier.

    NOTICE:
    When removing the bolt, keep the nut from rotating.