Home › SUSPENSION & AXLE › SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > INSPECTION

for Preparation Click here



1. INSPECT REAR STABILIZER LINK ASSEMBLY


    C066721
  1. Inspect the turning of the ball joint.

    1. Secure the rear stabilizer link assembly in a vise using aluminum plates.

    2. Install the nut to the rear stabilizer link assembly stud.

    3. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

      Torque:
      Turning torque:
      0.05 to 1.0 N*m{ 0.5 to 10 kgf*cm , 0.4 to 8.9 in.*lbf }

      HINT:
      If the turning torque is not within the specified range, replace the rear stabilizer link assembly with a new one.

  1. Inspect the dust cover.

    1. Check that the dust cover is not cracked and that there is no grease on it.