Home › SUSPENSION & AXLE › SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > REMOVAL

for Preparation Click here


NOTICE:
Check if an old gasket still remains on the pipe. If so, remove it. Also, check if any bolts or nuts are rusted. If so, replace them.



1. REMOVE REAR WHEELS


2. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 2AZ-FE)


  1. Remove the 2 bolts, 2 nuts and center exhaust pipe assembly.


    A135690E01

  1. Remove the gasket from the front exhaust pipe.



3. REMOVE TAIL EXHAUST PIPE ASSEMBLY (for 2GR-FE)


  1. Remove the 4 nuts and 2 exhaust tail pipes.


    A135718

  1. Remove the 2 gaskets from the exhaust tail pipes.



4. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 2GR-FE)


  1. Remove the 2 bolts, 2 nuts and exhaust center pipe assembly.


    A135719

  1. Remove the gasket from the exhaust center pipe assembly.



5. REMOVE REAR STABILIZER LINK ASSEMBLY LH


    C132493
  1. Remove the 2 nuts and rear stabilizer link assembly LH.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.



6. REMOVE REAR STABILIZER LINK ASSEMBLY RH


    C138761
  1. Remove the 2 nuts and rear stabilizer link assembly RH.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.



7. REMOVE REAR STABILIZER BAR NO. 2 BRACKET


    C139014
  1. Remove the 2 bolts and rear stabilizer bar No. 2 bracket.



8. REMOVE REAR STABILIZER BAR NO. 1 BRACKET


    C139015
  1. Remove the 2 bolts and rear stabilizer bar No. 1 bracket.



9. REMOVE REAR STABILIZER BUSHING
  1. Remove the 2 rear stabilizer bushings from the rear stabilizer bar.



10. REMOVE REAR STABILIZER BAR