Home › BODY ELECTRICAL › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU (INSTRUMENT PANEL J/B)
  1. Disconnect the IF and IM, ID junction block connectors.



  2. Disconnect the E7 and E9 main body ECU connectors.


    B139183E01

  3. Measure the resistance and voltage according to the value(s) in the table below.

    Symbols
    (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    GND1 (IF-10) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    GND2 (IM-9) - Body ground
    BECU (ID-10) - Body ground
    O - Body ground
    Power source
    Always
    10 to 14 V
    DCTY (E7-24) - Body ground
    L*1, Y*2 - Body ground
    Driver door courtesy light switch signal
    Switch pushed (Door closed)
    Below 1 Ω
    Switch free (Door opened)
    10 kΩ or higher
    KSW (E9-5) - Body ground
    L - Body ground
    Key unlock warning switch signal
    No key is in ignition key cylinder
    10 kΩ or higher
    Key is in ignition key cylinder
    Below 1 Ω
    *1: for LHD
    *2: for RHD

    HINT:
    If the result is not as specified, there may be a malfunction on the wire harness side.