Home › BODY › SEAT › SEAT HEATER SWITCH

SEAT HEATER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SEAT HEATER SWITCH


    B126240E02
  1. Inspect the driver side seat heater switch operation.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Position
      Specified Condition
      E55-6 (LH) - E55-5 (IG)
      OFF
      10 kΩ or higher
      E55-6 (LH) - E55-5 (IG)
      ON
      Below 1 Ω

      If the result is not as specified, replace the switch.

    2. Turn the seat heater switch on and check if the seat heater switch indicator comes on.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal E55-5 (IG)
      Battery negative (-) → Terminal E55-4 (E)
      Comes on

      If the result is not as specified, replace the switch.



    B126242E02
  1. Inspect the front passenger side seat heater switch operation.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Position
      Specified Condition
      E55-3 (RH) - E55-5 (IG)
      OFF
      10 kΩ or higher
      E55-3 (RH) - E55-5 (IG)
      ON
      Below 1 Ω

      If the result is not as specified, replace the switch.

    2. Turn the seat heater switch on and check if the seat heater switch indicator comes on.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal E55-5 (IG)
      Battery negative (-) → Terminal E55-4 (E)
      Comes on

      If the result is not as specified, replace the switch.



    B126241E02
  1. Check if the seat heater switch indicator comes on.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal E55-2 (ILL+)
    Battery negative (-) → Terminal E55-1 (ILL-)
    Comes on

    If the result is not as specified, replace the switch.