Home › ENGINE ยท 2AZ-FE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > INSPECTION

for Preparation Click here



1. INSPECT V-RIBBED BELT


    A131418E01
  1. Visually check the V-ribbed belt for excessive wear, frayed cords, etc. If any defect has been found, replace the V-ribbed belt.

    HINT:
    1. Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.
    2. A "new belt" is a belt which has been used for less than 5 minutes with the engine running.
    3. A "used belt" is a belt which has been used for 5 minutes or more with the engine running.