Home › BRAKE › BRAKE CONTROL › FRONT SPEED SENSOR

FRONT SPEED SENSOR > INSPECTION

for Preparation Click here



1. INSPECT FRONT SPEED SENSOR (w/o VSC)
  1. Inspect the front speed sensor. If any of the following occurs, replace the front speed sensor with a new one:

    1. The surface of the front speed sensor is cracked, dented, or chipped off.
    2. The connector or wire harness is scratched, cracked, or damaged.
    3. The front speed sensor has been dropped.



    C093876E16
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LH:
    Tester Connection
    Specified Condition
    1 (FL+) - 2 (FL-)
    1.4 to 1.8 kΩ at 20 °C (68°F)
    1 (FL+) - Body ground
    10 kΩ or higher
    2 (FL-) - Body ground
    10 kΩ or higher
    RH:
    Tester Connection
    Specified Condition
    1 (FR+) - 2 (FR-)
    1.4 to 1.8 kΩ at 20 °C (68°F)
    1 (FR+) - Body ground
    10 kΩ or higher
    2 (FR-) - Body ground
    10 kΩ or higher

    If the value is not as specified, replace the front speed sensor.



2. INSPECT FRONT SPEED SENSOR (w/ VSC)
  1. Inspect the front speed sensor. If any of the following occurs, replace the front speed sensor with a new one:

    1. The surface of the front speed sensor is cracked, dented, or chipped off.
    2. The connector or wire harness is scratched, cracked, or damaged.
    3. The front speed sensor has been dropped.



    C136017E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LH:
    Tester Connection
    Specified Condition
    1 (FL+) - 2 (FL-)
    1.4 to 1.8 kΩ at 20 °C (68°F)
    1 (FL+) - Body ground
    10 kΩ or higher
    2 (FL-) - Body ground
    10 kΩ or higher
    RH:
    Tester Connection
    Specified Condition
    1 (FR+) - 2 (FR-)
    1.4 to 1.8 kΩ at 20 °C (68°F)
    1 (FR+) - Body ground
    10 kΩ or higher
    2 (FR-) - Body ground
    10 kΩ or higher

    If the value is not as specified, replace the front speed sensor.