Home › BRAKE › BRAKE CONTROL › SKID CONTROL SENSOR

SKID CONTROL SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR WHEEL


2. DISCONNECT SKID CONTROL SENSOR WIRE


    C143907
  1. Disconnect the connector from the skid control sensor.

    NOTICE:
    Be careful not to damage the skid control sensor.



3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    C083014E02
  1. Remove the bolt and separate the flexible hose from the shock absorber.



    C145052E01
  1. Remove the 2 bolts and separate the rear disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.



4. REMOVE REAR DISC


    C132813E01
  1. Put matchmarks on the rear disc and the axle hub.



    C131914E02
  1. Release the parking brake and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn and press firmly the shoe adjuster until the wheel comes free.



5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY WITH SKID CONTROL SENSOR
  1. Disconnect the skid control sensor connector.



    C083035E01
  1. Remove the 4 bolts and hub and bearing assembly.



6. REMOVE SKID CONTROL SENSOR


    C111530E01
  1. Mount the rear axle hub and bearing assembly in a vise using aluminum plates.

    NOTICE:
    Replace the rear axle hub and bearing assembly if it is dropped or receives a strong shock.

  1. Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.

    SST
    09520-00031   (09521-00010, 09520-00040)
    09521-00020  

  1. Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub and bearing assembly.

    SST
    09520-00031   (09521-00010, 09520-00040)
    09521-00020  
    09950-00020  

    NOTICE:
    1. Keep the skid control sensor away from magnets.
    2. Pull the skid control sensor off straight, taking care not to make contact with the skid control sensor rotor.
    3. If the skid control sensor rotor is damaged or deformed, replace the rear axle hub and bearing assembly.
    4. Do not scratch the contact surface between the rear axle hub and bearing assembly and the skid control sensor.
    5. Do not attach foreign matter to the skid control sensor rotor and tip.