LIGHTING SYSTEM > Front Fog Light Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Turn the light control switch to the TAIL position.
Select the item below in the ACTIVE TEST and then check that the relay operates.
| Item | Test Details | Diagnostic Note |
| Front Fog Light Relay | Front fog light relay ON / OFF | - |
|
| ||||
| NG | |
| 2.INSPECT FUSE (FR FOG) |
Remove the FR FOG fuse from the instrument panel J/B assembly.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 3.INSPECT FOG LIGHT RELAY |
![]() |
Remove the front fog light relay from the instrument panel J/B assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| 3 - 5 | 10 kΩ or higher |
| Below 1 Ω (When battery voltage is applied to terminals 1 and 2) |
|
| ||||
| OK | |
| 4.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IC-1 - Body ground | Light control switch in TAIL and front fog light switch OFF → ON | Below 1 V → 10 to 14 V |
| ID-5 - Body ground | Light control switch in TAIL and front fog light switch OFF → ON | Below 1 V → 10 to 14 V |
|
| ||||
| NG | |
| 5.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IL-3 - Body ground | Light control switch OFF → TAIL | Below 1 V → 10 to 14 V |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (BETWEEN CONNECTOR IL-3 AND CONNECTOR IL-4) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IL-4 - Body ground | Light control switch OFF → TAIL | Below 1 V → 10 to 14 V |
|
| ||||
| OK | |
| Go to step 8 |
| 7.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
![]() |
Disconnect the II instrument panel J/B assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| II-8 - Body ground | Light control switch OFF → TAIL | Below 1 V → 10 to 14 V |
|
| ||||
| OK | |
| 8.CHECK HARNESS AND CONNECTOR (BODY ECU - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
![]() |
Disconnect the E7 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-4 - II-8 | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||