Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Door LOCK Position Circuit

for Preparation Click here


DESCRIPTION

The main body ECU receives each door lock position switch signal to control the illuminated entry system.

WIRING DIAGRAM


E121541E11


E121541E12


E133240E18


E133240E19


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the intelligent tester main switch on.

  1. Select the items below in the DATA LIST, and read the display on the intelligent tester.

    Main Body (Main Body ECU): without Entry and Start System 
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    D-Door Lock Pos SW
    Driver side door lock position switch signal / ON or OFF
    ON: Driver side door is unlocked
    OFF: Driver side door is locked
    -
    P-Door Lock Pos SW
    Passenger side door lock position switch signal / ON or OFF
    ON: Passenger side door or rear LH door or rear RH door is unlocked
    OFF: Passenger side door and rear LH door and rear RH door doors are locked
    -

    Main Body (Main Body ECU): (with Entry and Start System) 
    Tester Display
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    D-Door Lock Pos SW
    Driver side door lock position switch signal / ON or OFF
    ON: Driver side door is unlocked
    OFF: Driver side door is locked
    -
    P-Door Lock Pos SW
    Passenger side door lock position switch signal / ON or OFF
    ON: Passenger side door is unlocked
    OFF: Passenger side door is locked
    -
    RR-Door Lock Pos SW
    Rear right door lock position switch signal / ON or OFF
    ON: Rear right door is unlocked
    OFF: Rear right door is locked
    -
    RL-Door Lock Pos SW
    Rear left door lock position switch signal / ON or OFF
    ON: Rear left door is unlocked
    OFF: Rear left door is locked
    -

    OK:
    Normal conditions listed above are displayed.



NG
GO TO POWER DOOR LOCK CONTROL SYSTEM
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE