LIGHTING SYSTEM > Height Control Sensor Circuit |

| 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY |
![]() |
Connect 3 dry cell batteries (1.5 V) in series.
Remove the rear height control sensor sub-assembly.
Connect the positive (+) lead from the battery to terminal 3, and the negative (-) lead from the battery to terminal 1.
Measure the voltage between terminals 2 and 1 while slowly moving the link up and down.
| Tester Connection | Condition | Specified Condition |
| 2 (SHRR) - 1 (SHG) | +45° (High) | Approx. 4.05 V |
| 0° (Normal) | Approx. 2.25 V | |
| -45° (Low) | Approx. 0.45 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ECU - REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY) |
![]() |
Disconnect the O23 rear height control sensor sub-assembly connector.
Disconnect the A20 headlight beam level control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A20-12 (SBR) - O23-3 (SHB) | Always | Below 1 Ω |
| A20-19 (SHRL) - O23-2 (SHRR) | Always | Below 1 Ω |
| A20-21 (SGR) - O23-1 (SHG) | Always | Below 1 Ω |
| A20-12 (SBR) - Body ground | Always | 10 kΩ or higher |
| A20-19 (SHRL) - Body ground | Always | 10 kΩ or higher |
| A20-21 (SGR) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||