Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Headlight Leveling ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit detects the state of the ignition switch, and sends it to the headlight beam level control ECU.

WIRING DIAGRAM


B110607E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT BEAM LEVEL CONTROL ECU)


    E116070E03
  1. Disconnect the A20 headlight beam level control ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A20-1 (IG) - Body ground
    Ignition switch ON
    10 to 14 V
    A20-1 (IG) - Body ground
    Ignition switch OFF
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (HEADLIGHT BEAM LEVEL CONTROL ECU - BODY GROUND)


    E116070E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A20-9 (E1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE