Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only)

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only) > DATA LIST / ACTIVE TEST

for Preparation Click here



USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  2. Monitor the ECU data by following the prompts on the tester screen.

    HINT:
    The intelligent tester has a "Snapshot" function which records the monitored data. Refer to the intelligent tester operator's manual for further details.


DATA LIST

HINT:
Using the DATA LIST displayed on the intelligent tester, the value of the switches, sensors, actuators, etc. can be read without part removal. Reading the DATA LIST as the first step in troubleshooting is one way to shorten the labor time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Read the DATA LIST according to the display on the tester.

    D Door Motor: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door Auto SW
    Driver door power window auto switch signal/ON or OFF
    ON: Driver door power window auto switch operates
    OFF: Driver door power window auto switch does not operate
    -
    D Door P/W Up SW
    Driver door power window manual up switch signal/ON or OFF
    ON: Driver door power window manual up switch operates
    OFF: Driver door power window manual up switch does not operate
    -
    D Door P/W Down SW
    Driver door power window manual down switch signal/ON or OFF
    ON: Driver door power window manual down switch operates
    OFF: Driver door power window manual down switch does not operate
    -

    Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Communication Master SW
    Power window ECU communication signal OK/STOP
    OK: Communication is normal
    STOP: Communication is stop
    -
    Ignition Switch
    Ignition switch signal/ON or OFF
    ON: Ignition switch is on
    OFF: Ignition switch is off or ACC
    -
    D Door Courtesy SW
    Driver side door courtesy switch signal/ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -
    P Door Courtesy SW
    Front passenger side door courtesy switch signal/ON or OFF
    ON: Front passenger side door is open
    OFF: Front passenger side door is closed
    -


ACTIVE TEST

HINT:
Performing the ACTIVE TEST using the intelligent tester allows you to operate the relay, VSV, actuator, etc. without parts removal. Performing the ACTIVE TEST as the first step in troubleshooting is one way to shorten the labor time. It is possible to display the DATA LIST during the ACTIVE TEST.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Perform the ACTIVE TEST according to the display on the tester.

    D Door Motor: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Power window
    Operates power window UP/DOWN
    -

    Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    IG OFF P/W Control Permission Output
    Operates power window ON/OFF (After ignition OFF)
    -