Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only)

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only) > Driver Side Power Window Motor Circuit

for Preparation Click here


DESCRIPTION

This circuit transmits signals from the power window regulator master switch assembly to the power window regulator motor (Driver side).

WIRING DIAGRAM


B137064E04


INSPECTION PROCEDURE

1.INSPECT POWER WINDOW REGULATOR MOTOR


    B137055E01
  1. Remove the power window motor.

    1. Apply battery voltage to the motor connector according to the table below.

      NOTICE:
      Do not apply battery voltage to any terminals except terminals 1, 2, 4, 7 and 10.

      Standard:
      Switch Condition
      Measurement Condition
      Specified Condition
      Manual Operation
      Battery positive (+) → Terminal 2 (PWR)
      Battery negative (-) → Terminal 1 (E), 7 (DN)
      Motor gear rotates clockwise
      Battery positive (+) → Terminal 2 (PWR)
      Battery negative (-) → Terminal 1 (E), 10 (UP)
      Motor gear rotates counterclockwise
      Auto Operation
      Battery positive (+) → Terminal 2 (PWR)
      Battery negative (-) → Terminal 1 (E), 4 (AUTO), 7 (DN)
      Motor gear rotates clockwise
      Battery positive (+) → Terminal 2 (PWR)
      Battery negative (-) → Terminal 1 (E), 4 (AUTO), 10 (UP)
      Motor gear rotates counterclockwise



NG
REPLACE POWER WINDOW REGULATOR MOTOR
OK


2.CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - WINDOW REGULATOR MASTER SWITCH)


    B137046E05
  1. Disconnect the M1(L1) and I5 (H10) connectors.

    1. Measure the resistance according to the value(s) in the table below.

( ): RHD models

Standard resistance:
LHD models:
Tester Connection
Condition
Specified Condition
M1-8 (UP) - I5-10
Always
Below 1 Ω
M1-5 (DN) - I5-7
Always
Below 1 Ω
M1-8 (UP) - Body ground
Always
10 kΩ or higher
M1-5 (DN) - Body ground
Always
10 kΩ or higher
RHD models:
Tester Connection
Condition
Specified Condition
L1-8 (UP) - H10-10
Always
Below 1 Ω
L1-5 (DN) - H10-7
Always
Below 1 Ω
L1-8 (UP) - Body ground
Always
10 kΩ or higher
L1-5 (DN) - Body ground
Always
10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE