Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only)

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only) > Front Passenger Side Power Window Motor Circuit

for Preparation Click here


DESCRIPTION

This circuit transmits signals from the power window regulator switch assembly (Front passenger) to the power window regulator motor (Front passenger).

WIRING DIAGRAM


B137065E08


INSPECTION PROCEDURE

1.INSPECT POWER WINDOW REGULATOR MOTOR


    B127536E02
  1. Remove the power window motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor gear rotates counterclockwise



NG
REPLACE POWER WINDOW REGULATOR MOTOR
OK


2.CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - POWER WINDOW REGULATOR SWITCH)


    B137066E04
  1. Disconnect the H6 (I9) and H4 connectors.

  1. Measure the resistance according to the value(s) in the table below.
    ( ): RHD models

    Standard resistance:
    LHD models:
    Tester Connection
    Condition
    Specified Condition
    H6-4 (U) - H4-2
    Always
    Below 1 Ω
    H6-1 (D) - H4-1
    Always
    Below 1 Ω
    H6-4 (U) - Body ground
    Always
    10 kΩ or higher
    H6-1 (D) - Body ground
    Always
    10 kΩ or higher
    RHD models:
    Tester Connection
    Condition
    Specified Condition
    I9-4 (U) - H4-2
    Always
    Below 1 Ω
    I9-1 (D) - H4-1
    Always
    Below 1 Ω
    I9-4 (U) - Body ground
    Always
    10 kΩ or higher
    I9-1 (D) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE