Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only)

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only) > Rear Power Window Motor LH Circuit

for Preparation Click here


DESCRIPTION

This circuit transmits signals from the power window regulator switch assembly (Rear LH) to the power window regulator motor (Rear LH).

WIRING DIAGRAM


B137065E06


INSPECTION PROCEDURE

1.INSPECT POWER WINDOW REGULATOR MOTOR


    B127536E02
  1. Remove the power window motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor gear rotates counterclockwise



NG
REPLACE POWER WINDOW REGULATOR MOTOR
OK


2.CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - WINDOW REGULATOR SWITCH)


    B137066E02
  1. Disconnect the K1 and K3 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K1-4 (U) - K3-1
    Always
    Below 1 Ω
    K1-1 (D) - K3-2
    Always
    Below 1 Ω
    K1-4 (U) - Body ground
    Always
    10 kΩ or higher
    K1-1 (D) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE