POWER DOOR LOCK CONTROL SYSTEM > Rear Door UNLOCK Detection Switch LH Circuit |


| 1.SYSTEM CHECK |
Check the vehicle specification.
| Result | Proceed to |
| w/ Entry and Start System | A |
| w/o Entry and Start System | B |
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER (UNLOCK DETECTION SWITCH) |
Connect intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the tester.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| RL-Door Lock Pos SW | Rear left door lock position switch signal / ON or OFF | ON: Rear left door is unlocked OFF: Rear left door is locked | - |
|
| ||||
| OK | ||
| ||
| 3.INSPECT REAR DOOR LOCK ASSEMBLY (UNLOCK DETECTION SWITCH) |
![]() |
Remove the rear door lock assembly LH.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Measurement Condition | Door Lock Condition | Specified Condition |
| 6 - 9 | Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Lock | 10 kΩ or higher |
| 6 - 9 | Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlock | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (REAR DOOR LOCK ASSEMBLY - MAIN BODY ECU) |
Disconnect the rear door lock assembly LH connector.

Disconnect the junction block*1 or ECU*2 connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| K5-6 (LSSR) - IP-5*1 | Always | Below 1 Ω |
| K5-6 (LSSR) - E6-27 (LSWP)*2 | Always | Below 1 Ω |
| K5-6 (LSSR) - Body ground | Always | 10 kΩ or higher |
| K5-9 (E) - Body ground | Always | Below 1 Ω |
| Result | Proceed to |
| OK (w/ Entry and Start System) | A |
| OK (w/o Entry and Start System) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||