POWER DOOR LOCK CONTROL SYSTEM > Rear Door UNLOCK Detection Switch RH Circuit |

| 1.INSPECT REAR DOOR LOCK ASSEMBLY (UNLOCK DETECTION SWITCH) |
![]() |
Remove the rear door lock assembly RH.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Measurement Condition | Door Lock Condition | Specified Condition |
| 6 - 9 | Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Lock | 10 kΩ or higher |
| 6 - 9 | Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlock | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (REAR DOOR LOCK - MAIN BODY ECU (INSTRUMENT PANEL J/B)) |
![]() |
Disconnect the rear door lock assembly RH connector.
Disconnect the ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| J5-6 (LSSR) - E6-5 (LSWP) | Always | Below 1 Ω |
| J5-6 (LSSR) - Body ground | Always | 10 kΩ or higher |
| J5-9 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||