POWER DOOR LOCK CONTROL SYSTEM > Rear Door Lock Motor RH Circuit |

| 1.INSPECT REAR DOOR LOCK ASSEMBLY |
![]() |
Remove the rear door lock assembly RH.
Apply battery voltage and check operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Lock |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlock |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (REAR DOOR LOCK - MAIN BODY ECU (INSTRUMENT PANEL J/B)) |
Disconnect the rear door lock assembly RH connector.

Disconnect the ECU (instrument panel J/B) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| J5-4 (L) - IF-5 | Always | Below 1 Ω |
| J5-1 (UL) - IF-18 | Always | Below 1 Ω |
| IF-5 - Body ground | Always | 10 kΩ or higher |
| IF-18 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||