Home › BRAKE › BRAKE CONTROL › SKID CONTROL SENSOR

SKID CONTROL SENSOR > INSPECTION

for Preparation Click here



1. INSPECT SKID CONTROL SENSOR (w/o VSC)
  1. Inspect the skid control sensor. If any of the following occurs, replace the skid control sensor with a new one:

    1. The surface of the skid control sensor is cracked, dented, or chipped off.
    2. The connector is scratched, cracked, or damaged.
    3. The skid control sensor has been dropped.



    C113377E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LH:
    Tester Connection
    Specified Condition
    1 (RL+) - 2 (RL-)
    Below 2.2 kΩ
    1 (RL+) - Body ground
    10 kΩ or higher
    2 (RL-) - Body ground
    10 kΩ or higher
    RH:
    Tester Connection
    Specified Condition
    1 (RR+) - 2 (RR-)
    Below 2.2 kΩ
    1 (RR+) - Body ground
    10 kΩ or higher
    2 (RR-) - Body ground
    10 kΩ or higher

    If the value is not as specified, replace the skid control sensor.



2. INSPECT SKID CONTROL SENSOR (w/ VSC)
  1. Inspect the skid control sensor. If any of the following occurs, replace the skid control sensor with a new one:

    1. The surface of the skid control sensor is cracked, dented, or chipped off.
    2. The connector is scratched, cracked, or damaged.
    3. The skid control sensor has been dropped.



    C113377E07
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    RH:
    Tester Connection
    Condition
    Specified Condition
    2 (RR+) - 1 (RR-)
    Always
    0.9 to 2.1 kΩ
    2 (RR+) - Body ground
    Always
    10 kΩ or higher
    1 (RR-) - Body ground
    Always
    10 kΩ or higher
    LH:
    Tester Connection
    Condition
    Specified Condition
    2 (RL+) - 1 (RL-)
    Always
    0.9 to 2.1 kΩ
    2 (RL+) - Body ground
    Always
    10 kΩ or higher
    1 (RL-) - Body ground
    Always
    10 kΩ or higher

    If the value is not as specified, replace the skid control sensor.