AUDIO AND VISUAL SYSTEM > Radio Broadcast cannot be Received or Poor Reception |
| 1.CHECK RADIO RECEIVER |
Check the radio's automatic station search function.
Check the radio's automatic station search function by activating it.
|
| ||||
| NG | |
| 2.INSPECT RADIO RECEIVER |
![]() |
Disconnect the radio receiver connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ANT - Body ground | Ignition Switch is ON Radio SW ON | 10 to 14 V |
|
| ||||
| OK | |
| 3.CHECK OPTIONAL COMPONENTS |
Check optional components (sunshade film, telephone antenna, etc.).
Check if any optional components, such as sunshade film or telephone antenna that may decrease reception capacity, are installed.
|
| ||||
| NG | |
| 4.CHECK RADIO RECEIVER |
![]() |
Preparation for check
Remove the antenna plug from the radio receiver.
Check for noise
Turn the ignition switch to the ACC position with the radio receiver connector connected.
Turn the radio on and put into AM mode.
Place a screwdriver, thin wire, or other metal object on the radio receiver's antenna jack and check that noise can be heard from the speaker.
|
| ||||
| OK | |
| 5.CHECK GLASS ANTENNA |
![]() |
Check for continuity of the antenna.
|
| ||||
| OK | |
| 6.CHECK ANTENNA CORD |
Remove the antenna plug of the radio receiver and antenna.
Measure the resistance between the antenna and radio receiver to check for an open circuit in the antenna cord.
Measure the resistance between the antenna cord and body ground to check for a short circuit in the antenna cord.
|
| ||||
| OK | |
| 7.REPLACE AMPLIFIER ANTENNA |
Replace the amplifier antenna and check if radio broadcasts can be received normally.
|
| ||||
| NG | ||
| ||