TOYOTA PARKING ASSIST-SENSOR SYSTEM > Speed Signal Circuit |
| for 2AZ-FE |

| for 2GR-FE |

| 1.CHECK COMBINATION METER ASSEMBLY |
Inspect the circuits that send vehicle speed signals to the combination meter system (Click here).
During the inspection, if there is an instruction that indicates to go back to inspections for each system, proceed to the next step.
| NEXT | |
| 2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - COMBINATION METER ASSEMBLY) |
![]() |
Disconnect the F2 connector from the combination meter assembly and the S17 connector from the clearance warning ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S17-10 (SPD) - F2-12 (+S) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - NO. 3 JUNCTION BLOCK) |
Disconnect the S17 connector from the clearance warning ECU.

Disconnect the No. 3 junction block connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S17-10 (SPD) - 3B-10 | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||