METER / GAUGE SYSTEM > Engine Coolant Temperature Receiver Gauge Malfunction |
| for 2AZ-FE |

| for 2GR-FE |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication DTC is output (Click herefor LHD, Click here for RHD).
| Result | Proceed to |
| CAN communication DTC is not output. | A |
| CAN communication DTC is output. | B (Click herefor LHD, Click here for RHD) |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Enter the following menus: Diagnosis / OBD/MOBD / Combination Meter / Active Test.
Check the values by referring to the operation in the table below.
| Tester Display | Test Part | Control Range | Normal Condition |
| Water Temperature Meter Operation | Engine coolant temperature receiver gauge | Low, Normal, High | - |
|
| ||||
| OK | |
| 3.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Enter the following menus: Diagnosis / OBD/MOBD / Combination Meter / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Coolant Temperature | Engine coolant temperature: 0°C (-40°F) to 127.5°C (284°F) | After warming up: 80 to 95°C (176 to 203°F) |
|
|
| ||||
| OK | ||
| ||
| 4.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Enter the following menus: Diagnosis / OBD/MOBD / Engine / Data List.
Check the values by referring to the values in the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Coolant Temp | Engine coolant temperature: -40°C (-40°F) to 140°C (284°F) | 80 to 100°C (176 to 212°F): After warming up |
|
|
| ||||
| OK | |
| 5.REPLACE COMBINATION METER ASSEMBLY |
Replace the combination meter assembly with a new or a normal one.
|
| ||||
| OK | ||
| ||