Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows)

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows) > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER (REFERENCE)

HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function(s) can be customized.
  2. Be sure to make notes of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Power Window / Utility / Customize.

  5. Select the setting by referring to the table below.

    Power Window 
    Tester Display
    Default
    Content
    Setting
    Door Key Linked P/W Up
    ON
    This function is used to close the windows by operating the mechanical key.
    ON/OFF
    Door Key Linked P/W Down
    ON
    This function is used to open the windows by operating the mechanical key.
    ON/OFF
    P/W Up w/ Transmitter
    ON
    This function is used to close the windows using the wireless key transmitter.
    ON/OFF
    P/W Down w/ Transmitter
    ON
    This function is used to open the windows using the wireless key transmitter.
    ON/OFF
    P/W Up w/Smart*
    ON
    This function is used to close the windows using the door outside handle assembly (entry lock switch).
    ON/OFF
    w/ Entry and Start System