DTC P0340 Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0340 | Case 1
|
|

| Item | Content |
| Terminals | CH1: G2+ - G2- CH2: NE+ - NE- |
| Equipment Settings | 5 V/DIV. 20 ms./DIV. |
| Conditions | Cranking or idling |
| 1.INSPECT CAMSHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the C31 Camshaft Position (CMP) sensor connector.
Measure the resistance between terminals 1 and 2.
| Tester Connection | Specified Condition |
| 1 - 2 | 950 to 1,250 Ω |
Reconnect the CMP sensor connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the C31 CMP sensor connector.
Disconnect the C24 ECM connector.
Measure the resistance between the terminals of the wire harness side connectors.
| Tester Connection | Specified Condition |
| G2+ (C31-1) - G2+ (C24-99) | Below 1 Ω |
| G2- (C31-2) - G2- (C24-98) |
| Tester Connection | Specified Condition |
| G2+ (C31-1) or G2+ (C24-99) - Body ground | 10 kΩ or higher |
| G2- (C31-2) or G2- (C24-98) - Body ground |
Reconnect the ECM connector.
Reconnect the CMP sensor connector.
|
| ||||
| OK | |
| 3.CHECK SENSOR INSTALLATION (CAMSHAFT POSITION SENSOR) |
![]() |
Check the CMP sensor installation condition.
|
| ||||
| OK | |
| 4.CHECK VALVE TIMING |
![]() |
Remove the cylinder head cover.
Turn the crankshaft pulley, and align its groove with the timing mark "0" on the timing chain cover.
Check that the timing marks on the camshaft timing sprocket and camshaft timing gear are facing upward as shown in the illustration.
Reinstall the cylinder head cover.
|
| ||||
| OK | |
| 5.CHECK CAMSHAFT |
Check the teeth of the camshaft.
|
| ||||
| OK | |
| 6.REPLACE CAMSHAFT POSITION SENSOR |
| NEXT | |
| 7.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the tester on.
Clear the DTCs (Click here).
Start the engine.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| No output | A |
| P0340 | B |
|
| ||||
| A | ||
| ||