DTC P0340 Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0340 | When either of following conditions is met:
|
|

| ECM Terminal Name | CH1: Between G2+ and G2- CH2: Between NE+ and NE- |
| Tester Range | 5 V/DIV., 20 ms/DIV. |
| Condition | Idling with warm engine |
| 1.INSPECT CAMSHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the camshaft position sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Cold | 835 to 1400 Ω |
| 1 - 2 | Hot | 1060 to 1645 Ω |
| *1 | Component without harness connected (Camshaft Position Sensor) |
Reconnect the camshaft position sensor connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR - ECM) |
Disconnect the camshaft position sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C31-1 - C24-99 (G2+) | Always | Below 1 Ω |
| C31-2 - C24-98 (G2-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| C31-1 or C24-99 (G2+) - Body ground | Always | 10 kΩ or higher |
| C31-2 or C24-98 (G2-) - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the camshaft position sensor connector.
|
| ||||
| OK | |
| 3.CHECK SENSOR INSTALLATION (CAMSHAFT POSITION SENSOR) |
![]() |
Check the camshaft position sensor installation.
|
| ||||
| OK | |
| 4.CHECK VALVE TIMING |
![]() |
Remove the cylinder head cover.
Turn the crankshaft pulley, then align its groove with the timing mark "0" on the timing chain cover.
Check that the point marks on the camshaft timing gears are aligned with the timing chain cover surface as shown in the illustration.
If not, turn the crankshaft 1 revolution (360°), then align the marks as above.
| *1 | Alignment Marks |
| *2 | Groove |
Reinstall the cylinder head cover.
|
| ||||
| OK | |
| 5.INSPECT CAMSHAFT |
Check the teeth of the camshaft.
|
| ||||
| OK | |
| 6.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTCs (Click here).
Start the engine.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P0340 is output | B |
|
| ||||
| A | ||
| ||