Component
| Function
|
Door control transmitter
| - Has LOCK, UNLOCK, and LUGGAGE OPEN switches.
- Transmits weak radio waves (recognition codes and function codes) to the door control receiver.
- Illuminates the indicator light (LED) during transmission.
|
Door control receiver
| Receives weak radio waves (recognition codes and function codes) and outputs them as code data to the main body ECU.
|
- Front door courtesy light switch
- Rear door courtesy light switch
- Luggage compartment door courtesy light switch
| Turns on when a door is opened and turns off when it is closed. Outputs door status codes (open or closed) to the main body ECU.
|
Unlock warning switch
| Detects if the key is inserted in the ignition key cylinder or not.
|
Door lock position switch
| Transmits the door lock positions of each door to the main body ECU.
|
Main body ECU
| Sends wireless door lock control signals in response to the code data from the door control receiver and signals from each switch.
|
Function
| Operation
|
All door lock
| Pressing the LOCK switch locks all doors.
|
All door unlock
| Pressing the UNLOCK switch locks all doors.
|
Automatic lock
| If none of the doors is opened within 30 seconds after they are unlocked by the wireless door lock control, all the doors will lock again automatically.
|
Luggage compartment door opener
| Pressing the LUGGAGE OPEN switch of the transmitter opens the luggage compartment door.
|
Power window and sliding roof * open
| Pressing the UNLOCK switch for 2.4 seconds or more opens driver's side power window and sliding roof*.
|
Power window and sliding roof * close
| Pressing the LOCK switch for 2.4 seconds or more closes driver's side power window and sliding roof*.
|
Answer back
| - When the doors are locked by wireless operation, the hazard warning lights flash once.
- When the doors are unlocked by wireless operation, the hazard warning lights flash twice.
|
Illuminated entry
| When all the doors are locked, pressing UNLOCK causes the interior lights to come on simultaneously with the unlock operation.
|
Self-diagnostic mode
| The following are ways to enter the self-diagnostic mode:
- If the door control receiver receives normal radio waves from the door control transmitter when the system is in diagnostic mode, it flashes the interior light in a normal pattern that corresponds to the function of each switch.
- Read DTCs with the intelligent tester.
|
Transmitter recognition code registration
| Enables the registration (writing and storing) of 6 types of transmitter recognition codes in the EEPROM that is contained in the door control receiver.
|