Home › ENGINE ยท 2AZ-FE › ENGINE CONTROL SYSTEM › CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY


    A093611E01
  1. Apply a light coat of engine oil to an O-ring of the camshaft timing oil control valve assembly sensor.



    A124556
  1. Install the camshaft timing oil control valve assembly sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Connect the camshaft timing oil control valve assembly sensor connector.



2. INSTALL CLIP NUT


    A135665E01
  1. Install the clip nut.



3. REMOVE VACUUM HOSE CLAMP


    A135664
  1. Install the vacuum hose clamp with the bolt.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


    A134904
  1. Install the engine cover with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }