Home
›
ENGINE · 2AZ-FE
›
ENGINE CONTROL SYSTEM
›
CRANKSHAFT POSITION SENSOR
CRANKSHAFT POSITION SENSOR > INSPECTION
for Preparation
Click here
1. INSPECT CRANKSHAFT POSITION SENSOR
Using an ohmmeter, measure the resistance between the terminals.
Standard resistance:
Temperature
Specified Condition
Cold
985 to 1,600 Ω
Hot
1,265 to 1,890 Ω
NOTICE:
"Cold" and "Hot" mean the temperature of the coils themselves. "Cold" is from -10 to 50°C (14 to 122 °F) and "Hot" is from 50 to 100°C (122 to 212°F).
If the resistance is not as specified, replace the sensor.