Home › ENGINE ยท 2AZ-FE › EMISSION CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL AIR FUEL RATIO SENSOR
  1. Temporarily tighten the air fuel ratio sensor.

    NOTICE:
    Do not damage the air fuel ratio sensor.



    A135684E01
  1. Using SST, fully tighten the air fuel ratio sensor.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }



    A135681E01
  1. Connect the air fuel ratio sensor connector and clamp.



2. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A135682
  1. Install the exhaust manifold heat insulator with the 4 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }