Home › ENGINE ยท 2AZ-FE › EMISSION CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A135682
  1. Remove the 4 bolts and No. 1 exhaust manifold heat insulator.



2. REMOVE AIR FUEL RATIO SENSOR


    A135681E01
  1. Disconnect the air fuel ratio sensor connector and clamp.



    A135683E01
  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold converter sub-assembly No. 2.

    SST
    09224-00010  

    NOTICE:
    Do not damage the air fuel ratio sensor.