POWER DOOR LOCK CONTROL SYSTEM > OPERATION CHECK |
| CHECK ELECTRICAL DOOR LOCK OPERATION |
Check the basic function.
Check that all doors lock when the door control switch (for manual operation) is turned to LOCK and all doors unlock when turned to UNLOCK.
Check that all doors lock when the driver side door lock key cylinder is turned to LOCK using the mechanical key.
Check the key lock-in prevention function.
Have the key inserted into the ignition key cylinder.
With the driver side door open, check that all doors unlock immediately after the door lock knob for the driver side door is turned to LOCK.
With the driver side door open, check that all doors unlock immediately after the door control switch (for manual operation) is turned to LOCK.
With the driver side door open, turn the driver side door lock knob to LOCK, and then close the driver side door. Then check that all doors unlock.
Check the security function.
Close all doors with the driver side door window open so that the door control switch can be operated from outside the vehicle.
Pull out the mechanical key (transmitter), open the driver side door and then close and lock the door using the mechanical key (transmitter). Under this condition, check that all doors do not unlock when the door control switch (for manual operation) is turned to UNLOCK from outside the vehicle.
Pull out the mechanical key, and close and lock the driver side door by mechanical key operation. Under this condition, check that all doors do not unlock when the door control switch (for manual operation) is turned to UNLOCK from outside the vehicle.
Pull out the mechanical key (transmitter), close the driver side door, and lock the door by wireless door lock operation. Under this condition, check that all doors do not unlock when the door control switch (for manual operation) is turned to UNLOCK from outside the vehicle.
Check the illumination function.
Set the room light switch to the DOOR position.
With all doors locked, check that all doors unlock when the driver side door lock cylinder is turned to UNLOCK using the key. At the same time, the room light comes on.
Check that the room light goes off in approximately 15 seconds if the doors have not been opened.
Check the automatic locking function interlocked with the shift lever.
When any door is unlocked with all doors closed and the engine started, check that all doors automatically lock when the shift lever is moved into any position from the P position (A/T).
When any door is unlocked after all doors automatically lock, check that all doors attempt to automatically lock once again (retry function). The retry function is canceled when any of the following conditions is fulfilled: