Home › BODY › WINDSHIELD / WINDOWGLASS › FRONT PASSENGER SIDE POWER WINDOW SWITCH

FRONT PASSENGER SIDE POWER WINDOW SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW SWITCH (for Models with Jam Protection Function on Driver Door Window Only)


    B102538E01
  1. Remove the power window switch.

  1. Measure the resistance when the switch is operated according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (D) - 2 (SD)
    UP
    Below 1 Ω
    3 (B) - 4 (U)
    Below 1 Ω
    1 (D) - 2 (SD)
    OFF
    Below 1 Ω
    4 (U) - 5 (SU)
    Below 1 Ω
    4 (U) - 5 (SU)
    DOWN
    Below 1 Ω
    1 (D) - 3 (B)
    Below 1 Ω



2. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Models with Jam Protection Function on 4 Windows)


    B193518E13
  1. Check the switch function.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      6 (UP) - 1 (GND)
      Auto up or up position
      Below 1 Ω
      7 (DOWN) - 1 (GND)
      Auto down or down position
      Below 1 Ω
      8 (AUTO) - 1 (GND)
      Auto up or auto down position
      Below 1 Ω
      6 (UP) - 1 (GND)
      Free
      10 kΩ or higher
      7 (DOWN) - 1 (GND)
      Free
      10 kΩ or higher
      8 (AUTO) - 1 (GND)
      Free
      10 kΩ or higher

      If the result is not as specified, replace the power window regulator switch assembly (for front passenger side).



    B193518E23
  1. Check that the LED illuminates.

    1. Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 4 (LED)
      Battery negative (-) → 1 (GND)
      LED illuminates

      If the result is not as specified, replace the power window regulator switch assembly (for front passenger side).