Home › BRAKE › BRAKE CONTROL › BRAKE ACTUATOR (w/ VSC)

BRAKE ACTUATOR (w/ VSC) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE RADIATOR RESERVE TANK ASSEMBLY


    C143552
  1. Separate the radiator reserve tank hose.



    C144510E03
  1. Remove the radiator reserve tank assembly.



3. DRAIN BRAKE FLUID

NOTICE:
If brake fluid leaks onto any painted surface, immediately clean it off completely.



4. REMOVE BRAKE ACTUATOR WITH BRAKE ACTUATOR BRACKET ASSEMBLY


    C133326E01
  1. Release the lock lever and disconnect the brake actuator connector.



    C133324E01
  1. Using SST, disconnect the 6 brake lines from the brake actuator with brake actuator bracket assembly.

    SST
    09023-00101  



    C133323E01
  1. Use tags or make a memo to identify the places to reconnect.

    HINT:
    1. *1: To Front Wheel Cylinder RH
    2. *2: To Front Wheel Cylinder LH
    3. *3: To Rear Wheel Cylinder RH
    4. *4: To Rear Wheel Cylinder LH
    5. *5: From 1st Master Cylinder
    6. *6: From 2nd Master Cylinder



    C133325E01
  1. Remove the 3 bolts and brake actuator with brake actuator bracket assembly from the body.

    NOTICE:
    Do not damage the brake lines and wire harness.