REAR VIEW MONITOR SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
| |||||
| 4.PROBLEM SYMPTOM CONFIRMATION |
| Result | Proceed to |
| Symptom does not occur | A |
| Symptom occurs | B |
|
| ||||
| |||||
| 5.SYMPTOM SIMULATION |
| |||||
| 6.CHECK DTC |
Check for DTCs and note any codes that are output (Click here).
Clear the DTC (Click here).
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
| System | Proceed to |
| Navigation System |
Click here
|
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 7.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
|
| ||||
| |||||
| 8.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW |
Refer to Terminals of ECU (Click here).
| |||||
| 9.ADJUST, REPAIR OR REPLACE |
| |||||
| 10.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|