Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW REGULATOR MOTOR

POWER WINDOW REGULATOR MOTOR > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR MOTOR (FRONT PASSENGER)


    B127536E02
  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor gear rotates counterclockwise



2. INSPECT POWER WINDOW REGULATOR MOTOR (DRIVER SIDE)


    B137055E01
  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1, 2, 4, 7 and 10.

    Standard:
    Switch Condition
    Measurement Condition
    Specified Condition
    Manual Operation
    Battery positive (+) → Terminal 2 (PWR)
    Battery negative (-) → Terminal 1 (E), 7 (DN)
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 2 (PWR)
    Battery negative (-) → Terminal 1 (E), 10 (UP)
    Motor gear rotates counterclockwise
    Auto Operation
    Battery positive (+) → Terminal 2 (PWR)
    Battery negative (-) → Terminal 1 (E), 4 (AUTO), 7 (DN)
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 2 (PWR)
    Battery negative (-) → Terminal 1 (E), 4 (AUTO) 10 (UP)
    Motor gear rotates counterclockwise



3. INSPECT POWER WINDOW REGULATOR MOTOR (REAR RH)


    B127536E02
  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor gear rotates counterclockwise



4. INSPECT POWER WINDOW REGULATOR MOTOR (REAR LH)


    B127535E01
  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal
    Motor gear rotates counterclockwise