Home › BODY ELECTRICAL › LIGHTING › STOP LIGHT SWITCH

STOP LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STOP LIGHT SWITCH ASSEMBLY


    E065594E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    1 - 2
    Switch pin free
    Below 1 Ω
    Switch pin pushed in
    10 kΩ or higher
    3 - 4
    Switch pin free
    10 kΩ or higher
    Switch pin pushed in
    Below 1 Ω

    If the result is not as specified, replace the stop light switch assembly.