Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > Diagnosis Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking of the SRS warning light.

HINT:
  1. When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
  2. A DTC output mode signal is transmitted through CAN communication system to each ECU including the center airbag sensor assembly. Thus when all systems do not enter DTC output mode, there may be an ECM malfunction.


WIRING DIAGRAM


C123785E01


C123786E01


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click herefor LHD, Click here for RHD).

    Result:

    Condition
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
A


2.CHECK WIRE HARNESS (DLC3 - ECM)


    E126838E07
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the connector from the ECM.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    for 2GR-FE (LHD):
    Tester Connection
    Condition
    Specified Condition
    E10-13 (TC) - A55-27 (TC)
    Always
    Below 1 Ω
    for 2GR-FE (RHD) and for 2AZ-FE:
    Tester Connection
    Condition
    Specified Condition
    E10-13 (TC) - A24-27 (TC)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS (TC OF DLC3 - TC OF ECM)
OK


3.CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND)


    C126742E26
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E10-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS (CG OF DLC3 - BODY GROUND)
OK


4.CHECK WIRE HARNESS (TC OF ECM - BODY GROUND)


    E126835E07
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    for 2GR-FE (LHD):
    Tester Connection
    Condition
    Specified Condition
    A55-27 (TC) - Body ground
    Always
    1 MΩ or higher
    for 2GR-FE (RHD) and for 2AZ-FE:
    Tester Connection
    Condition
    Specified Condition
    A24-27 (TC) - Body ground
    Always
    1 MΩ or higher



NG
REPAIR OR REPLACE WIRE HARNESS OR EACH ECU
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)