FUEL SENDER GAUGE ASSEMBLY (for 2AZ-FE) > INSPECTION |
| 1. INSPECT FUEL SENDER GAUGE ASSEMBLY |
![]() |
Remove the fuel sender gauge assembly.
Check that the float moves smoothly between F and E.
Measure the resistance between the terminals 2 (S) and 3 (FE) of connector according to the value(s) in the table below.
| Float Level | Resistance (Ω) |
| F | 13.5 to 16.5 |
| Between E and F | 13.5 to 414.5 (Gradually changes) |
| E | 405.5 to 414.5 |