Home › BODY ELECTRICAL › METER › FUEL SENDER GAUGE ASSEMBLY (for 2GR-FE)

FUEL SENDER GAUGE ASSEMBLY (for 2GR-FE) > INSPECTION

for Preparation Click here



1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    E132667E01
  1. Remove the fuel sender gauge assembly.

  1. Check that the float moves smoothly between F and E.

  1. Measure the resistance between the terminals 2 (S) and 3 (FE) of connector according to the value(s) in the table below.

    Standard resistance:
    Float Level
    Resistance (Ω)
    F
    13.5 to 16.5
    Between E and F
    13.5 to 414.5 (Gradually changes)
    E
    405.5 to 414.5

    HINT:
    If the value is not as specified, replace the fuel sender gauge assembly.