METER / GAUGE SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT SPEEDOMETER |
Check the operation.
Using a speedometer tester (calibrated chassis dynamometer), check the speedometer indication according to the table below.
| Chassis dynamometer indication | Acceptable range Data in ( ) is for reference |
| 20 km/h | 21.0 to 25.0 km/h |
| 40 km/h | 41.7 to 46.2 km/h |
| 60 km/h | 62.7 to 67.2 km/h |
| 80 km/h | 83.4 to 88.4 km/h |
| 100 km/h | 104.3 to 109.3 km/h |
| 120 km/h | 125.1 to 130.6 km/h |
| 140 km/h | 145.8 to 151.8 km/h |
| 160 km/h | 166.2 to 173.2 km/h |
| 180 km/h | 188.9 to 194.5 km/h |
| 200 km/h | 207.7 to 215.7 km/h |
| 220 km/h | 228.4 to 236.8 km/h |
| 240 km/h | 249.2 to 258.0 km/h |
Check the deviation from the acceptable range of the speedometer indication.
| 2. INSPECT TACHOMETER |
Connect a tune-up tachometer, and start the engine.
Compare the test results with the tachometer indications.
| Tune-up tachometer indication (rpm) | Acceptable range Data in ( ) is for reference |
| 700 | 630 to 770 |
| 1,000 | (900 to 1,100) |
| 2,000 | (1,850 to 2,150) |
| 3,000 | 2,800 to 3,200 |
| 4,000 | (3,800 to 4,200) |
| 5,000 | 4,800 to 5,200 |
| 6,000 | (5,750 to 6,250) |
| 7,000 | 6,700 to 7,300 |
| 8,000 | (7,700 to 8,300) |
| 3. INSPECT ENGINE OIL PRESSURE SWITCH |
Disconnect the connector from the engine oil pressure switch.
Turn the ignition switch to the ON position.
Ground the terminal of the wire harness side connector.
Turn the ignition switch to the ON position, and engine idling for 10 seconds or more.
| 4. INSPECT MULTI-INFORMATION DISPLAY |
![]() |
Turn the ignition switch off.
Press the "DISP" button and hold it down.
Turn the ignition switch to the ON position.
Ignition switch off to finish this test mode.