Home › BODY › MIRROR › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > INSPECTION

for Preparation Click here



1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH


    B227979E01
  1. Inspect outer mirror motor operation.

    1. Apply battery voltage and check operation of the mirror face, as shown in the table and illustration.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 6 (MV)
      Battery negative (-) → Terminal 5 (M+)
      Turns upward (A)
      Battery positive (+) → Terminal 5 (M+)
      Battery negative (-) → Terminal 6 (MV)
      Turns downward (B)
      Battery positive (+) → Terminal 4 (MH)
      Battery negative (-) → Terminal 5 (M+)
      Turns left (C)
      Battery positive (+) → Terminal 5 (M+)
      Battery negative (-) → Terminal 4 (MH)
      Turns right (D)

  1. Inspect retract mirror operation.

    1. Apply battery voltage and check operation of the mirror face, as shown in the table below.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 10 (MF)
      Battery negative (-) → Terminal 11 (MR)
      Returns (Driving position)
      Battery positive (+) → Terminal 11 (MR)
      Battery negative (-) → Terminal 10 (MF)
      Retracts

  1. Inspect outer mirror heater operation.

    1. Apply battery voltage and check operation of the mirror face, as shown in the table below.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 3 (H+)
      Battery negative (-) → Terminal 8 (H-)
      Mirror surface temperature becomes higher



2. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH


    B227978E01
  1. Inspect outer mirror motor operation.

    1. Apply battery voltage and check operation of the mirror face, as shown in the table and illustration.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 6 (MV)
      Battery negative (-) → Terminal 5 (M+)
      Turns upward (A)
      Battery positive (+) → Terminal 5 (M+)
      Battery negative (-) → Terminal 6 (MV)
      Turns downward (B)
      Battery positive (+) → Terminal 4 (MH)
      Battery negative (-) → Terminal 5 (M+)
      Turns left (C)
      Battery positive (+) → Terminal 5 (M+)
      Battery negative (-) → Terminal 4 (MH)
      Turns right (D)

  1. Inspect retract mirror operation.

    1. Apply battery voltage and check operation of the mirror face, as shown in the table below.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 10 (MF)
      Battery negative (-) → Terminal 11 (MR)
      Returns (Driving position)
      Battery positive (+) → Terminal 11 (MR)
      Battery negative (-) → Terminal 10 (MF)
      Retracts

  1. Inspect outer mirror heater operation.

    1. Apply battery voltage and check operation of the mirror face, as shown in the table below.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 3 (H+)
      Battery negative (-) → Terminal 8 (H-)
      Mirror surface temperature becomes higher