Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY

FRONT SEAT INNER BELT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH


B140749E01
  1. Measure the resistance between terminals of the switch when the switch is operated.

    HINT:
    1. This is the inspection procedure of the inner belt switch for the tension reducer.
    2. The circuit of the seat belt warning or airbag system cannot be inspected by this procedure.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Seat belt is fastened
    Below 1 Ω
    3 - 4
    Seat belt is unfastened
    10 kΩ or higher



2. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH


B140749E01
  1. Measure the resistance between terminals of the switch when the switch is operated.

    HINT:
    1. This is the inspection procedure of the inner belt switch for the tension reducer.
    2. The circuit of the seat belt warning or airbag system cannot be inspected by this procedure.

    Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Seat belt is fastened
    Below 1 Ω
    3 - 4
    Seat belt is unfastened
    10 kΩ or higher