DTC P0793 Intermediate Shaft Speed Sensor "A" |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0793 | ECM detects conditions (a), (b) and (c) continuously for 5 sec. or more: (1-trip detection logic)
|
|

| Terminal | NC+ - NC- |
| Tool setting | 1 V/DIV., 1ms./DIV. |
| Vehicle condition | Vehicle speed 30 km/h (19 mph): (3rd gear) Engine speed 1,400 rpm |

| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn on the tester.
Select the item "Enter / Powertrain / ECT / Data List".
Follow the instructions on the tester and read the Data List.
| Item | Measurement Item/ Range (display) | Normal Condition |
| SPD (NC) | Counter Gear Speed/ display: 50 r/min | [HINT] 3rd when shift lever position is D position (After warming up the engine);
|
| 1.INSPECT SPEED SENSOR INSTALLATION |
![]() |
Check the speed sensor installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR (NC) |
![]() |
Disconnect the speed sensor connector from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition 20 °C (68 °F) |
| 1 - 2 | 560 to 680 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR - ECM) |
![]() |
Connect the speed sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition 20 °C (68 °F) |
| C24-101 (NC+) - C24-102 (NC-) | 560 to 680 Ω |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| C24-101 (NC+) - Body ground | 10 kΩ or higher |
| C24-102 (NC-) - Body ground |
|
| ||||
| OK | ||
| ||