DTC P0741 Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve DSL) |
| DTC No. | DTC Detection CondS1ition | Trouble Area |
| P0741 | Lock-up does not occur when driving in the lock-up range (normal driving at 80 km/h [50 mph]), or lock up remains ON in the lock-up OFF range. (2-trip detection logic) |
|
| ACTIVE TEST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester together to the DLC3.
Turn the ignition switch to the ON position.
Turn on the tester.
Select the item "Enter / Powertrain / ECT / Active Test".
Follow the instructions on the tester and read the Active Test.
| Item | Test Details | Diagnostic Note |
| Control the Lock Up | [Test Details] Control the shift solenoid DSL to set the automatic transmission to the lock-up condition. [Vehicle Condition]
| Possible to check the DSL operation. |
Lightly depress the accelerator pedal and check that the engine speed does not change abruptly.

| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0741) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn on the tester.
Select the item "Powertrain / ECT / DTC / Current or Pending".
Read the DTCs using the intelligent tester.
| Display (DTC output) | Proceed to |
| Only "P0741" is output | A |
| "P0741" and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT TRANSMISSION WIRE (DSL) |
![]() |
Disconnect the transmission wire connector from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition 20°C (68°F) |
| 10 - Body ground | 11 to 13 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
![]() |
Connect the transmission wire connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition 20°C (68°F) |
| C24-79 (DSL) - Body ground | 11 to 13 Ω |
|
| ||||
| OK | |
| 4.INSPECT SHIFT SOLENOID VALVE (DSL) |
![]() |
Remove the shift solenoid valve DSL.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition 20°C (68°F) |
| Solenoid Connector (DSL) - Solenoid Body (DSL) | 11 to 13 Ω |
Connect the positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.
|
| ||||
| OK | |
| 5.CHECK TRANSMISSION WIRE |
|
| ||||
| OK | |
| 6.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
|
| ||||
| OK | |
| 7.INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
|
| ||||
| OK | ||
| ||