DTC P0724 Brake Switch "B" Circuit High |
| DTC No. | DTC Detecting Condition | Trouble Area |
| P0724 | The stop light switch remains ON even when the vehicle is driven in a STOP (less than 3 km/h (2 mph) and GO (30 km/h (19 mph) or more) fashion 5 times. (2-trip detection logic). |
|
| 1.READ VALUE USING DATA LIST |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn on the tester.
Select the item "Enter / Powertrain / ECT / Data List".
Follow the instructions on the tester and read the Data List.
| Item | Measurement Item/ Range (display) | Normal Condition |
| Stop light SW | Stop light switch Status/ ON or OFF |
|
|
| ||||
| NG | |
| 2.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch assembly.
Measure the resistance according to the value(s) in the table below.
| Switch position | Tester Connection | Specified Condition |
| Switch pin free | 1 - 2 | Below 1 Ω |
| Switch pin pushed in | 10 kΩ or higher | |
| Switch pin free | 3 - 4 | 10 kΩ or higher |
| Switch pin pushed in | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - ECM) |
![]() |
Install the stop light switch assembly.
Measure the voltage according to the value(s) in the table below when the brake pedal is depressed and released.
| Condition | Tester Connection | Specified Condition |
| Brake pedal is depressed | A24-36 (STP) - Body ground | 10 to 14 V |
| Brake pedal is released | Below 1 V |
|
| ||||
| OK | ||
| ||