DTC P0798 Pressure Control Solenoid "C" Electrical (Shift Solenoid Valve SL3) |
| DTC No. | DTC Detecting Condition | Trouble Area |
| P0798 |
|
|

| 1.INSPECT TRANSMISSION WIRE (SL3) |
![]() |
Remove the TCM from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition 20°C (68°F) |
| 16 (SL3+) - 15 (SL3-) | 5.0 to 5.6 Ω |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| 16 (SL3+) - Body ground | 10 kΩ or higher |
| 15 (SL3-) - Body ground | 10 kΩ or higher |
|
| ||||
| NG | |
| 2.INSPECT SHIFT SOLENOID VALVE (SL3) |
![]() |
Remove the shift solenoid valve SL3.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition 20°C (68°F) |
| 1 - 2 | 5.0 to 5.6 Ω |
Connect a positive (+) lead through a 21 W bulb to terminal 2 and a negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.
|
| ||||
| OK | ||
| ||