POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only) > OPERATION CHECK |
| CHECK WINDOW LOCK SWITCH |
![]() |
Check that the front passenger side power window and rear power windows operation are disabled when the window lock switch of the power window master switch is pressed.
Check that the front passenger side power window and rear power windows can be operated when the window lock switch is pressed again.
| CHECK MANUAL UP/DOWN FUNCTION |
Check that the driver side power window operates as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Ignition switch ON | Driver side | Pulled halfway up | UP (Closed) |
| Pushed halfway down | DOWN (Open) |
Check that the power windows except the driver side power window operates as follows:
| Condition | Switch | Switch Operation | Power Window |
| Passenger side | Pulled up | UP (Closed) |
| Pushed down | DOWN (Open) | ||
| Rear LH | Pulled up | UP (Closed) | |
| Pushed down | DOWN (Open) | ||
| Rear RH | Pulled up | UP (Closed) | |
| Pushed down | DOWN (Open) |
| CHECK AUTO UP/DOWN FUNCTION |
Check that the driver side power window operates as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Ignition switch ON | Driver side | Pulled up fully | UP (Closed) |
| Pushed down fully | DOWN (Open) |
| CHECK REMOTE MANUAL UP/DOWN FUNCTION |
Check that the power windows except the driver side power window operate as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Passenger side | Pulled up | UP (Closed) |
| Pushed down | DOWN (Open) | ||
| Rear LH | Pulled up | UP (Closed) | |
| Pushed down | DOWN (Open) | ||
| Rear RH | Pulled up | UP (Closed) | |
| Pushed down | DOWN (Open) |
| CHECK JAM PROTECTION FUNCTION |
![]() |
Check the reversing distance.
Fully open the door glass.
Place a check jig measuring 4 to 10 mm (0.16 to 0.40 in.) thick near the window fully closed position.
When the door glass is closed using AUTO or MANUAL operation, check that the door glass goes down after contacting the check jig. The glass should go 200 to 240 mm away from the position where it contacted the check jig.
While the door glass is going down, verify that the window switch can not be used to make the glass go up.
Check the reversing distance.
Fully open the door glass.
Place a check jig measuring 200 to 250 mm (7.90 to 9.84 in.) thick near the window fully closed position.
When the door glass is closed using AUTO or MANUAL operation, check that the door glass goes down after contacting the check jig. The door glass should go 80 to 100 mm away from the position where it contacted the check jig.
While the door glass is going down, verify that the window switch can not be used to make the glass go up.