Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows)

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows) > OPERATION CHECK

for Preparation Click here



CHECK WINDOW LOCK SWITCH
B140183

HINT:
Before performing the window lock switch operation check, make sure that the window lock switch is off (the switch is not pushed in).

  1. Check that the front passenger and rear windows cannot be operated from each power window regulator switch assembly (front passenger side, rear LH side or rear RH side) when the window lock switch of the power window regulator master switch assembly is pushed in.

    OK:
    Front passenger and rear windows are disabled.

    HINT:
    Even when the window lock switch of the power window regulator master switch assembly is pushed in, remote manual up and down and auto up and down functions can be operated.

  2. Check that the front passenger and rear windows can be operated from each power window regulator switch assembly (front passenger side, rear LH side or rear RH side) when the window lock switch of the power window regulator master switch assembly is pushed in again.

    OK:
    Front passenger and rear windows operate normally.


CHECK MANUAL UP / DOWN FUNCTION
  1. Check that the driver side power window operates as follows:

    OK 
    Condition
    Master Switch
    Switch Operation
    Power Window
    Ignition switch ON
    Driver side
    Pulled halfway up
    UP (Closes)
    Pushed halfway down
    DOWN (Opens)

  2. Check that the front passenger side window and rear power windows operate as follows:

    OK 
    Condition
    Regulator Switch
    Switch Operation
    Power Window
    1. Ignition switch ON
    2. Window lock switch off
    Front passenger side
    Pulled halfway up
    UP (Closes)
    Pushed halfway down
    DOWN (Opens)
    Rear LH side
    Pulled halfway up
    UP (Closes)
    Pushed halfway down
    DOWN (Opens)
    Rear RH side
    Pulled halfway up
    UP (Closes)
    Pushed halfway down
    DOWN (Opens)


CHECK AUTO UP / DOWN FUNCTION
  1. Check that the driver side power window operates as follows:

    OK 
    Condition
    Master Switch
    Switch Operation
    Power Window
    Ignition switch ON
    Driver side
    Pulled up (One touch operation)
    AUTO UP (Closes)
    Pushed down (One touch operation)
    AUTO DOWN (Opens)

  2. Check that the front passenger side window and rear power windows operate as follows:

    OK 
    Condition
    Regulator Switch
    Switch Operation
    Power Window
    1. Ignition switch ON
    2. Window lock switch off
    Front passenger side
    Pulled up (One touch operation)
    AUTO UP (Closes)
    Pushed down (One touch operation)
    AUTO DOWN (Opens)
    Rear LH side
    Pulled up (One touch operation)
    AUTO UP (Closes)
    Pushed down (One touch operation)
    AUTO DOWN (Opens)
    Rear RH side
    Pulled up (One touch operation)
    AUTO UP (Closes)
    Pushed down (One touch operation)
    AUTO DOWN (Opens)


CHECK REMOTE MANUAL UP / DOWN FUNCTION
  1. Check that the front passenger side window and rear power windows operate as follows:

    OK 
    Condition
    Master Switch
    Switch Operation
    Power Window
    Ignition switch ON
    Front passenger side
    Pulled halfway up
    UP (Closes)
    Pushed halfway down
    DOWN (Opens)
    Rear LH side
    Pulled halfway up
    UP (Closes)
    Pushed halfway down
    DOWN (Opens)
    Rear RH side
    Pulled halfway up
    UP (Closes)
    Pushed halfway down
    DOWN (Opens)


CHECK REMOTE AUTO UP / DOWN FUNCTION
  1. Check that the front passenger side window and rear power windows operate as follows:

    OK 
    Condition
    Master Switch
    Switch Operation
    Power Window
    Ignition switch ON
    Front passenger side
    Pulled up (One touch operation)
    AUTO UP (Closes)
    Pushed down (One touch operation)
    AUTO DOWN (Opens)
    Rear LH side
    Pulled up (One touch operation)
    AUTO UP (Closes)
    Pushed down (One touch operation)
    AUTO DOWN (Opens)
    Rear RH side
    Pulled up (One touch operation)
    AUTO UP (Closes)
    Pushed down (One touch operation)
    AUTO DOWN (Opens)


CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH IS TURNED OFF
  1. Check that all the power windows can be operated with the power widow regulator master switch assembly and power window regulator switch assemblies (for front passenger side, rear LH and RH sides) after the ignition switch is turned off.

    HINT:
    If the window lock switch is on, the windows cannot be operated using the power window regulator switch assemblies (for front passenger, rear LH and RH sides). Therefore, turn the window lock switch off before checking the window operation.

  2. Check that the key-off operation function does not operate after the driver side door or front passenger side door is opened.

    HINT:
    Even if the driver door or front passenger door is opened during automatic window operation while the key-off operation function is on, the window will continue operating.

  3. Check that all the power windows cannot be operated after more than approximately 45 seconds have elapsed since the ignition switch was turned off.


CHECK KEY-LINKED FUNCTION USING DRIVER SIDE DOOR KEY CYLINDER
  1. Check that all power windows operate as follows:

    OK 
    Condition
    Door Key Cylinder Operation
    Power Window
    No key is inside vehicle, and all doors are closed
    Held (LOCK) for more than 1.5 seconds
    UP (Closes)
    No key is inside vehicle, and all doors are closed
    Returned to neutral position
    STOP
    No key is inside vehicle, and all doors are closed
    Held (UNLOCK) for more than 1.5 seconds
    DOWN (Opens)
    No key is inside vehicle, and all doors are closed
    Returned to neutral position
    STOP


CHECK WIRELESS TRANSMITTER-LINKED FUNCTION
  1. Check that all power windows operate as follows when operating the transmitter:

    OK 
    Condition
    Transmitter Operation
    Power Window
    No key is inside vehicle, and all doors are closed and locked
    UNLOCK switch pressed for more than 3.0 seconds
    DOWN (Opens)
    No key is inside vehicle, and all doors are closed and locked
    UNLOCK switch released
    STOP
    No key is inside vehicle, and all doors are closed and locked
    LOCK switch pressed for more than 3.0 seconds
    UP (Closes)
    No key is inside vehicle, and all doors are closed and locked
    LOCK switch released
    STOP


CHECK ENTRY LOCK SWITCH-LINKED CLOSE FUNCTION (w/ Entry and Start System)
  1. Check that all power windows operate as follows when the entry lock switch is pressed and held:

    OK 
    Condition
    Transmitter Operation
    Power Window
    No key is inside vehicle, and all doors are closed
    Entry lock switch pressed for more than 3.0 seconds
    UP (Closes)
    No key is inside vehicle, and all doors are closed
    Entry lock switch released
    STOP


CHECK JAM PROTECTION FUNCTION


  1. Check the basic function.

    CAUTION:
    Do not put your fingers between the door frame and door glass to check the jam protection function. Also, prevent any part of your body from being caught during inspection.

    HINT:
    The jam protection function is operative during both the auto up and manual up operations while the engine is running or the ignition switch is ON, and also 45 sec. have elapsed after the ignition switch is turned off.


    1. Fully open the window.



    2. B203476E01
    3. Set a thick book wrapped with a piece of cloth near the window fully closed position.

    4. Operate the auto up or manual up function to check that the power window goes down after the book is caught between the window and door frame, and stops when the opening reaches approximately 200 mm (7.87 in.).

      HINT:
      The power window moves down approximately 125 mm (4.93 in.). However, when the opening does not reach 200 mm (7.87 in.), the power window continues to go down until the opening reaches 200 mm (7.87 in.) or until approximately 5 seconds elapse.

    5. While the power window is moving down, check that the door glass cannot be raised when the power window switch is used.


CHECK POWER WINDOW SWITCH LED ILLUMINATION


    B203478E01
  1. Check the LED illumination (power window regulator master switch assembly).

    1. Check that the LEDs located on the power window regulator master switch assembly illuminate when the ignition switch is turned to ON.



  2. B193530E01
  3. Check the LED illumination (power window regulator switch assembly).

    1. Check that the LEDs located on each power window regulator switch assembly illuminate when the ignition switch is turned to ON.

      HINT:
      If the window lock switch is on, the LED located on each power window regulator switch assembly does not illuminate. Therefore, turn the window lock switch off before checking the LED illumination.