PARK / NEUTRAL POSITION SWITCH > INSTALLATION |
| 1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Move the shift lever to the N position.
![]() |
Align the protrusions of the park/neutral position switch.
![]() |
Install the park/neutral position switch to the control shaft with the 2 bolts.
![]() |
Install the control shaft lever to the control shaft with the nut and washer.
Connect the connector to the park/neutral position switch.
![]() |
Connect the transmission control cable to the transmission control cable bracket with a new clip.
![]() |
Connect the transmission control cable to the control shaft lever with the nut.
| 2. INSTALL AIR CLEANER BRACKET |
![]() |
Install the air cleaner bracket with the 3 bolts.
Install the wire harness clamp.
| 3. INSTALL NO. 1 AIR CLEANER INLET |
![]() |
Install the No. 1 air cleaner inlet with the bolt.
| 4. INSTALL AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Install the air cleaner case with the 3 bolts.
Connect the vacuum hose and hose clamp.
| 5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Install the air cleaner cap sub-assembly, and connect the 3 bands.
![]() |
Connect the mass air flow meter connector (*1).
Connect the No. 2 ventilation hose (*2).
Connect the hose band (*3).
![]() |
Connect the 3 vacuum hoses.
| 6. INSTALL AIR CLEANER INLET ASSEMBLY |
![]() |
Install the air cleaner inlet with the clamp and 2 bolts.
| 7. INSTALL COOL AIR INTAKE DUCT SEAL |
![]() |
Install the intake duct seal with the 7 clips.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION |
Apply the parking brake.
Turn the ignition switch on (IG).
Depress the brake pedal and check that the engine starts when the shift lever is set in the N or P position, but does not start in other positions.
Check that the back-up light comes on and the reverse warning buzzer sounds when the shift lever is set in the R position, but the light and buzzer do not operate in other positions. If a failure is found, check the park/neutral position switch for continuity.
| 10. INSPECT SHIFT LEVER POSITION |
When shifting from the P to the R position with the ignition switch on (IG) and brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.
Start the engine and make sure that the vehicle moves forward when shifting from the N to the D position and moves rearward when shifting to the R position.
If operation cannot be done as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.
| 11. ADJUST SHIFT LEVER POSITION |
Move the shift lever to the N position.
![]() |
Remove the nut and transmission control cable from the control shaft lever.
![]() |
Align the protrusions of the park/neutral position switch.
![]() |
Move the slider in the directions indicated by the arrows and pull up the lock piece.
![]() |
Install the control cable to the control shaft with the nut.
![]() |
Push in the lock piece.
Start the engine and make sure that the vehicle moves forward when moving the lever from the N to the D position and moves rearward when moving it to the R position. If it becomes hard to move the shift lever, readjust the shift lever position.